High-quality, "build-your-own" cable kit suitable for generally any motorcycle throttle application
One end of the inner wire is fitted with a carb nipple (nominally 3mm dia x 3mm). The opposite end will need to be cut to length and the required nipple soldered into place.
PLEASE NOTE: We strongly discourage the use of a propane type torch to heat and flow solder into the wire. This is likely to overheat the wire, causing it to become brittle and break. We recommend immersing the wire ends in a molten solder bath, such as that in a solder pot.
The ferrules and adjusters are a snug fit. They may be bonded into place if preferred, or you can use a center punch to make a small indention in the side.
The Kit Includes:
1.35 meters (4.4 feet/4 feet 4.8 inches/52.8 inches) of 6mm OD black PVC coated, spiral wound, Teflon lined outer conduit
1.6 meters (5.2 feet/5 feet 3 inches/63 inches) of 1.5mm OD galvanized steel wire (7 x 7 strand)
2 ferrules, 5mm OD nose
2 ferrules, 6.5mm OD nose
1 6mm x 1.00 x 32mm mid-adjuster
1 6mm x 1.00 x 32mm adjuster screw with nut
2 neoprene adjuster boots
1 brass carburettor nipple, 3mm DIA x 3mm (1.9mm bore)
1 brass barrel nipple, 5mm DIA x 7.5mm (1.9mm bore)
1 brass barrel nipple, 5.75mm DIA x 5.5mm (1.4mm bore)
1 brass barrel nipple, 6mm DIA x 4.2mm (1.7mm bore)
1 brass barrel nipple, 6mm DIA x 8mm (2.1mm bore)
1 brass barrel nipple, 6mm DIA x 10mm (2.1mm bore)